*****OPEESA Certified*****

Lawn Equipment

 Service or Tune up Information

Consumer Lawnmowers        $69.95 + parts

• Check air, fuel, ignition, compression
• Perform an engine leakdown test (helps determine engine condition)
• Check over all controls
• Check drive system (where applicable)
• Check condition of chassis and wheels
• Change engine oil (and filter where applicable), air filter, spark plug
• Adjust OHV valve clearance (where applicable) 
• Lube controls and cables
• Sharpen and balance blade-clean under deck
• Adjust controls and belt (where applicable)
• Test run and make any other necessary adjustments

After an initial analysis of unit-if it is deemed that more work than a serviceor "tune up" will cover is needed-an estimate will be provided first.

Consumer Rider (Single blade rear engine *NOT ZERO TURN*)$99.95 + parts

• Check air, fuel, ignition, compression
• Perform an engine leakdown test (helps determine engine condition)
• Check over all controls
• Check drive system condition
• Check condition of belt(s)
• Check condition of chassis and wheels
• Replace spark plug, air filter, and fuel filter
• Change engine oil (and filter where applicable)
• Adjust OHV valve clearance (where applicable) 
• Lube controls, cables, and chassis
• Sharpen and balance blade(s)-clean under deck-check deck level
• Adjust controls and belt(s)
• Set tire pressures
• Test run and make any other necessary adjustments

After an initial analysis of unit-if it is deemed that more work than a service or "tune up" will cover is needed-an estimate will be provided first.

Consumer Tractor & Zero Turn       $129.95 + parts

• Check air, fuel, ignition, compression
• Perform an engine leakdown test (helps determine engine condition)
• Check over all controls
• Check drive system condition
• Check condition of belt(s)
• Check condition of chassis and wheels
• Replace spark plug, air filter, and fuel filter
• Change engine oil (and filter where applicable)
• Adjust OHV valve clearance (where applicable) 
• Lube controls, cables, and chassis
• Sharpen and balance blade(s)-clean under deck-check deck level
• Adjust controls, belt(s), and PTO clutch (where applicable)
• Set tire pressures
• Ensure any other PTO for any other implements works properly
• Test run and make any other necessary adjustments

After an initial analysis of unit-if it is deemed that more work than a service or "tune up" will cover is needed-an estimate will be provided first.

Copyright © 2002 Elite Equipment Repair LLC. All rights reserved.